MD + is an elastic one-component sealant suitable for the gas and watertight sealing of cable entries. With the application of the MD+ sealant, you will protect valuable assets from damage which is caused by gas and water leaks.
Gas and watertight according to NEN 2768
The MD+ sealant is easily applied from a skeleton gun. The high quality, one component, flexible sealant “MD+” is based on a silicon compound that cures with air (Humidity).
After application and full curing the thixotropic MD+ forms a plastic elastomer mass with special qualities effectively sealing and bonding, while providing a high level of durability.
FEATURES
- Flexible, one component, adhesive and sealing compound in a cartridge - (310ml)
- High levels of Gas and Water tightness
- Removable / Re-enterable
- Excellent adhesion, applicable to all common building materials
- Shows Fire resistance properties
- Resistant against Water, Alkaline, Chemical agents
- Resistant to Hydrogen Sulphide / Methane and many other Gases (NedLab)
- Non corrosive
- Solvent free
- Shock absorbing
- Non toxic, neutral and almost odourless
- Suitable for any shaped duct / bore hole / opening
- Quick and easy installation
- Seals all know materials, PVC & PE sheathed cables, PILC, (HD) PE pipes
- Suitable for renovations, can be installed retrospectively
SPECIFICATIONS
MEASURE |
VALUE |
STANDARD |
Density |
1.2 gr/cm³ |
|
Flow |
< 2mm |
ISO 7390 |
Colour |
red-brown |
|
Skin over time (23C/55%RH) |
± 15 minutes |
|
Curing |
1.5mm / 24 hours |
|
Hardness |
30 shore A |
|
Elongation |
100% |
DIN 53504 |
Tensile strength |
0.8 N/mm² |
DIN 53504 |
Operating temperature |
+5°C tot +40°C |
|
Temperature resistance |
-40°C tot +120°C |
|