Get access to the socket-outlets of a charging station to perform safety and functional tests, while simulating the presence of an electric vehicle The EV520 Series Test Adapter Kis is designed to test function and safety of charging stations mode 3 for AC charging. The kit allows you to conduct tests in combination with appropriate test instruments like an installation tester (for example the Beha-Amprobe ProInstall Series) and/or Scope Meters (oscilloscope) (for example Fluke 120B Series Industrial ScopeMeter handheld oscilloscopes). With the Adapter Kit, the charging stations can be tested in accordance with IEC/EN 61851-1 and IEC/HD 60364-7-722.
FEATURES
- Suitable to vehicle charging stations with charging mode 3
- EV-connectors for type 2 and type 1
- PE Pre-Test: With this safety feature the PE conductor will be tested for possible presence of dangerous voltage against earth.
- Proximity Pilot (PP) state “Cable Simulation”: With PP State rotary switch the adapter can simulate various current capabilities of charging cables.
- Control Pilot (CP) state “Vehicle Simulation”: With CP State rotary switch selector various charging states can be simulated.
- Separate phase indication by three LED lamps for easy check if voltage is present.
- Measuring terminals L1, L2, L3, N and PE to connect test device like installation tester to perform safety and functional tests.
- Mains socket offering the possibility to connect an external load to check if the electric power meter works and counts in the right manner.
- Simulation of CP error “E”
- Simulation of PE error (Earth fault)
- Terminals for CP signal output to check communication between adapter (=simulated electrical vehicle) and charging station. This could be measured by a scopemeter. The voltage level defines the charging modes and the duty cycle of this PWM (Pulse Width Modulation) signal defines the charging current.
- IP 54 rating - Dust and splashing water protected
DATASHEET