0800 442 182
+64 9 274 3340 (NZ)
Asset Protection & Insulating Covers
Cable Glands & Duct Seals
Cable Protection & Lubricants
Circuit Protection & Fuses
ECOLight LED & Smart Energy Solutions
Hazardous Area Solutions
Helical Line Fittings
HV ABC Products
Earthing & Jumpers
LV ABC Products
LV Cable Accessories
MV Cable Accessories
Overhead Covered Conductor Systems - CCT, HV/LV ABC
Pillars & Pits
Telco Cable Accessories
Test & Measurement
EV Simulators, Tools & Safety Kits
> EV520 Test Adapter Kit for Electric Vehicle Charging Stations
EV520 Test Adapter Kit for Electric Vehicle Charging Stations
Move mouse over the image to magnify
Get access to the socket-outlets of a charging station to perform safety and functional tests, while simulating the presence of an electric vehicle The EV520 Series Test Adapter Kis is designed to test function and safety of charging stations mode 3 for AC charging. The kit allows you to conduct tests in combination with appropriate test instruments like an installation tester (for example the Beha-Amprobe ProInstall Series) and/or Scope Meters (oscilloscope) (for example Fluke 120B Series Industrial ScopeMeter handheld oscilloscopes). With the Adapter Kit, the charging stations can be tested in accordance with IEC/EN 61851-1 and IEC/HD 60364-7-722.
Suitable to vehicle charging stations with charging mode 3
EV-connectors for type 2 and type 1
PE Pre-Test: With this safety feature the PE conductor will be tested for possible presence of dangerous voltage against earth.
Proximity Pilot (PP) state “Cable Simulation”: With PP State rotary switch the adapter can simulate various current capabilities of charging cables.
Control Pilot (CP) state “Vehicle Simulation”: With CP State rotary switch selector various charging states can be simulated.
Separate phase indication by three LED lamps for easy check if voltage is present.
Measuring terminals L1, L2, L3, N and PE to connect test device like installation tester to perform safety and functional tests.
Mains socket offering the possibility to connect an external load to check if the electric power meter works and counts in the right manner.
Simulation of CP error “E”
Simulation of PE error (Earth fault)
Terminals for CP signal output to check communication between adapter (=simulated electrical vehicle) and charging station. This could be measured by a scopemeter. The voltage level defines the charging modes and the duty cycle of this PWM (Pulse Width Modulation) signal defines the charging current.
IP 54 rating - Dust and splashing water protected
You might also be interested in ...
Electric Vehicle Service Kits
EV Charging Station Simulators
Signup for Juice & Email Specials
TransNet Juice is a regular industry publication that delivers our latest news, products and special offers to industry members. Our email specials are available for purchase through all good electrical wholesalers.
+64 9 274 3340 (NZ)
+61 417 387 489 (AUS)
+64 9 274 5490
78 Cryers Road, East Tamaki
Auckland, New Zealand
PO Box 8117, Summerland Point
NSW 2259, Australia
Follow us on Facebook