This 3-Way Open/Switching Point Link Pillar is predominately used for standard link and isolation procedures and load balancing in low voltage distribution networks. The TE Tappat Link Pillar is designed to be used in a 3 phase, 400 Volt, 50 Hz MEN distribution system. To connect/disconnect or parallel LV feeders.
Contact us to order
KEY FEATURES
- 3x linked mains connections from 185mm2 to 300mm2 as standard, by changing the standard grub screws, this unit can accommodate 70mm2 up to 150mm2 cable
- Designed for Al or Cu round or sector cables
- 6 service ports per phase, 1x70mm2 and 2x50mm2 per each side of the unit
- Staggered main connections run vertically to minimise cable crossings
- Phases independently separated and insulated
- Easier, faster and safer to install and operate
DATASHEET
Tappat LV Link Pillar Datasheet
